Brand New Planetary/Gear Reduction Starter for all 1600's and 2000's. Easy install no modification required.

There are 2 different versions of this starter. 1 which is longer in length than the other. We have always opt for the shorter version, OVERALL LENGTH 7 1/4 to 3/8 INCHES, for the obvious clearance issues and OURS work with our headers and also AC Industries headers.

Another Datsun Parts first. We were the very first vendor, without question, to offer this starter.

Overshadowing even the U20 starter with superior torque, this unit also features a Bendix gear that pops out, engages the ring gear before it starts turning, thus saving the ring gear teeth from eventual wear. In addition, this unit is fully sealed and enclosed not vulnerable to rear main seal oil spun up on the back side of the flywheel which in un-sealed antique open snout designs, like the 1600 and 2000, usually results in the starter filling up with oil leading to poor electrical contact and brush breakdown. Most of the 1600 and 2000 starters have been around for 30 years having been heated up burnt-to-death and rebuilt 10 or 15 times (which is usually the case). Fits with all brands of headers.

All our starters work with the original exhaust manifold and headers

Our alternators are comprehensively re-manufactured units with new positive post insulating bushings. On any unit, be sure not to over tighten the nut on the positive alternator post as it can crack and destroy the plastic insulator.

HIGH OUTPUT 63 AMP ALTERNATOR W/INTERNAL REGULATOR -
MUCH BETTER THAN ORIGINAL ESPECIALLY IF YOU ARE USING HALOGEN LIGHTS AND A HIGH OUTPUT STEREO SYSTEM. THE FUSE SUPPLIED IS 30 AMP. CHANGING THE FUSE TO A HIGHER VALUE CAN COMPROMISE THE WIRING AND OR DAMAGE ELECTRONICS RESULTING IN FIRE, IF A DEAD SHORT OCCURS

Battery cables should be completely detached when working with electrical installations. Installed electrical parts are non returnable.

68 - 70 Alternator order by PART# 1240B $219.00.

NOTE: This alternator can be used for 65 - 67 1/2 cars. It requires shortening the front of the cast iron mount to align the pulley grooves on the water pump and crank and washering the back end of the bolt to make up for the difference or finding a shorter bolt. Mindfully decide whether you believe you are capable to perform these adjustments before making a purchase, as alternators are not returnable

U.S. made and dimensionally the same as original.Why buy another vendors overpriced offering that is $50.00 more?
Fits most new style 24 group batteries. Some batteries run smaller then original 24 group batteries. Check yours before ordering.
Choose your battery carefully as there are no returns on this item for lack of fitment.
Simply center over battery and tighten.

(1st PHOTO) Drawing & control sample

(2nd PHOTO) - 3 in a row Left to right. Original Nissan Battery frame Stan's and our replica. IDENTICAL

1346A: (3rd PHOTO) Battery frame, Nissan tray w/drain hose. Use your old hardware.
$75.00

1346B: (4th PHOTO) Battery frame, Nissan tray w/ drain hose, aftermarket correctly bent rods, washers, and wing nuts. 117.00