Customer / Manufacturer Quotes about Datsun Parts
Nissan/OEM/AfterMarket Differences
Ordering, Shipping, Returns, Policies
Limits of Liability Statement Important Read
| Images | Categories | Description | Price |
|---|---|---|---|
        |
Restoration Products Suspension |
Partnumber: 2113 Datsun Roadster & Fairlady Super Comp Springs - Exclusive Design AFTERMARKET USA NOTE: Some Datsun 510 owners use our springs to lower the rear of their cars. 410, 411 users for the front SUPER COMP SPRINGS PASS OUR 100 DOLLAR BILL CLEARANCE TEST WITH 7 QUART NISSAN RACING OIL PAN (SEE PHOTO) We have received fantastic feedback from everyday drivers and racers alike. Works great with both oil pans with room to spare. No issues with broken oil pans when using OUR comp spring set. 1st PHOTO: Shows a typical Super Comp install complete with our competition sway bar. Absolutely, positively no alignment, safety issues or geometry problems or wheel fender interference using this lowering kit. Approved and exclusively used, as the spring of choice, by Spriso Motorsports on all their SR20 conversions. Rate of this spring is 860 lbs - Length 8.750". You must shorten your original tall bump stops or buy our short comp bump stops, part number 1890 and shorten them .375 to provide the proper clearance needed between the top of the bump stop to the bottom of the upper control arm. Not shortening the bump stop will cause the bump stop to bottom out creating a harshness in ride. You can also use our part number 2174 urethane spacer under the springs to add more clearance or to adjust the height for street or race use. Free to those who purchase a set of springs, just ask and we will add them into the order. Using the same vehicle, we completed a extensive, controlled, proper and fair test of this spring as compared with one other manufacturers product currently on the market.Our spring is lowest of them all without question! Great for racing or on the street!! To order this spring set with the O-ring pads Order by PART# 2113PAD $175.00 Special Note For 510 Owners: We have detailed instructions and a superb review from Dave Witt who installed a set of our springs. Just ask and we will send it out with your order. 3rd PHOTO: and following 2 photos are of a non restored, unmodified, 3rd owner car. We wanted a car that was very original. This car has stock Nissan springs front and rear. The 2nd set of 3 photos were taken with the Super Comp springs installed. Springs were tested using a Larson Flash 36 load tester rated with a 5,000lb cell which cost $90,000. Not tested on a $1,000.00 Summit Nascar cage less spring tester. Wire hardness tested on a US made Newage calibrated Brinell hardness tester 7000. |
$135.00 PR |